WaterSensor+ can be connected to Linkbox+ using physical buttons or via the Abralife app. This article shows connection without the use of an app, but you can also read the article Adding a new device in the Abralife user manual.
ATTENTION!
- Linkbox+ must be connected to power before the procedure below is carried out. WaterSensor+ must be connected to battery or mains power. See chapter 6 and chapter 7 for details.
- The signal strength is weaker during pairing than in normal operation. It is therefore recommended that the wireless sensors are paired at a short distance from the Linkbox (BEFORE they are placed in the home).
1. Press the Linkbox+ button briefly (<1 second) to activate pairing mode. Pairing mode is indicated by the status light on Linkbox+ pulsing with a BLUE light .
2. Press and hold the button on the wireless sensor for approx. 2 seconds Release the button when the sensor's droplet symbol starts flashing rapidly BLUE. The devices will now connect.
3. Successful pairing is indicated by an acoustic signal and 3 GREEN flashes in the status light. Repeat the procedure for each new sensor to be paired.
NOTE! All water sensors must be function tested after pairing. See the article Functional test for instructions.
Full user manual for Watersensor+ is available here.
Comments
0 comments
Please sign in to leave a comment.